Ecumaster Digital ECU Tuner 3

Product omschrijving

Technical details:

• Four 16×16 side tables (fuel map,two PWM tables, ignition table),
• 8 Correctiontables 16×1,
• 2 independent switchable map sets ,
• Possibility modification of one analogue signal,
• 4 analogueinputs,
• Inbuilt Data Flash – possibility of logging without connected PC,
• Battery voltage monitoring ,
• Support of frequency output air flow meter (possibility of signal modification) 17Hz-4kHz,
• Support VR and Hall effect crank sensors together with ignition modules pulse. Device supportbothsingle ended and differential signals,
• Supports a lot of crank trigger patterns :60-2, 36-2, 36-1, Multitooth, Ignition Modules and more,
• Support of waste gate valve,
• Output for 4 saturated injectors (“full group”),
• ON/OFF parametricoutput,
• Automatic conversion of MAP to MAF with the use of the learning algorithm,
• Launch control,
• Road dyno,
• Possibility individual calibration of each analogue sensors – device displayed values with correct units,
• Free firmware update – new crank trigger patterns and new functionality,
• Fuel Implant mode –possibility of drive injectors in standalone mode (batch fire),
• USB communication no additional interface needed,
• 24 months warranty.

PC Requirements:

To properly work with the DET3 device following minimum is required.

• Windows 2000, XP, Vista, Windows 7, Windows 8
• Screen resolution of at least 1024×768 16bit
• CPU with a clock of at least 600MHz,
• USB port.

What is in the box

• Digital Ecu Tuner 3 device,
• USB AA lead,
• Connector,
• Set of terminals,
• CD with softwarenecessary drivers and user manual,
• Set of resistors and diode which may be useful during installation.